38810 Workstation Message Dispatch WMD: Unsupported Workstation protocol Gravure Japanese_Newspaper_OEM_Engine Lotem_400_Fiber_Head_Machine Lotem_800_Fiber_Head_Machine Lotem_Quantum Magnus_400 Magnus_800 Magnus_VLF Thermoflex Think_Motion_Controller Trendsetter_400/800 The firmware was unable to negotiate proper communications with the workstation. The type of command protocol attempted by the workstation is not supported on the device. Check the workstation software to make sure it is configured for the right type of recorder device. A device error has occurred: You may be able to continue by pressing the "resume" button onscreen (if present) or by resetting the device and workstation. For support under your service contract, contact the Creo Response Center at 1-(800) 472-2727 or online at http:\\eCentral.creo.com (or your local service representative) To speed troubleshooting, please make a note of error numbers, the media type/size and any information about the workflow or job that might be relevant. This error is reported. The workstation software has attempted to communicate to the device, but was probably configured for a different type of device. 08-JAN-2001 Automated conversion to new FW1 error template. ..\..\ShowAllErrors.htmFirmware 1 Error Index ..\..\ShowAllCommands.htmFirmware 1 Command Index ..\..\ShowAllParameters.htmFirmware 1 Parameter Index Updated: Thu Jul 17 07:23:16 2008 PST